White LED Light Rings, GL1800 Gold Wing 12-17 / F6B (pr)

White LED Light Rings, GL1800 Gold Wing 12-17 / F6B (pr)
MSRP:  $99.95

Add some functional flair to the front sides of your Gold Wing or F6B.  (will not work on F6C Valkyrie)
Includes LED Rings for both sides.

The brightest LED Rings you will find for your GL1800 or F6B, 12-17.
Each Custom LED Ring is packed with 93 nano size LED’s.  These are as bright as Daytime Running Lights.

Mounted around the Gold Wing Logos with 3M installed Tape.
 
Kit comes with LED Rings, Connectors, Instructions.
These LED Ring’s may also be used for Running and Turn Signals by adding a Single to Dual Intensity Converter (sold separately).
Click Here for Video:  White Rings also showing front of Bike

Click Here for Video:  Amber Rings with Mirror LED Turn Signals

Right Side LED Ring Installation:
Remove Right side Fairing Trim Accent by SQUEEZING the Sides and PULLING up gently.  We also use plastic Auto Body Panel tools.
REMOVE Right Pocket or Cover.
Test Fit the LED Ring on Right Side.
HOLD The LED Ring Upside Down in place and MARK for Wiring at approximate five O’clock position.
DRILL a 1/8” Hole for wiring.
CLEAN Insert around Honda Emblem with alcohol and let dry.
REMOVE 3M Tape Backing, Then INSTALL LED Ring.

LEFT Side LED Ring Installation:
REPEAT Right Side Installation for Left Side.
Left Pocket can be removed by PRESSING DOWN the Center of the four Lock Pins in each corner with a small Flathead Screwdriver,
Then PULL upwards to pull out the Pocket.

Wiring can be installed several ways:
Option 1:  On all the time with Ignition Key on.
Right Side, Using supplied T-Taps CONNECT Ring Wires into the Hot and Ground supplying the switch for the Heated Grips.  Connector should still be there even if you don’t have that option.
Left Side, Using supplied T-Taps, CONNECT Plus and Minus Ring Wires to the wires before the Three Pin Plug under the Left Pocket.

Option 2:  On all the time with Ignition Key on.
For F6B Use Kuryakyn Adapter Plugs for Front Turn Signals and Running Lights (GL1800 Goldwing tap into wiring at Mirror connectors).
PLUG the Adapter Plugs into Bike then hook up to LED's.

Option 3:  Switched On or Off.
Use power from the Three Pin Plug under the Left Pocket, (Power only when Bike is turned on) or power from any other source running through a switch to the Rings.
You may also use the Kuryakyn Master Cylinder Reservoir Cover Accessory Switches to power up the LED.  (KUR-7803)

These LED Ring’s may also be used for Running and Turn Signals by adding a Single to Dual Intensity Converter (sold separately).  The Turn Signal Wire will go into one input of the Converter while the Running Light Wire (Option 1, 2 or 3 above) will go into the other input.

This Product is covered under a one year manufactures warranty.