24" LED Flex Strip Jumpers, different lengths available $1.45 each

LED Flex Strip Jumpers, different lengths available

  These jumpers have connectors on both ends, allowing you to connect directly to the LED Flex Strip.  For hooking up power, just cut one of the ends off.  We have found that the 15" jumpers are pretty much the most common and most used.  You will probably want to get at least one or two of the 39" jumpers also.   The jumpers also are covered with a protective black heat shrink, making them durable and unnoticeable.

EASY INSTALLATION:
- Cut the Flex Strip (where indicated) to desired lengths, up to 13 pieces. 
- Place each piece onto the chosen area with the adhesive on the back of each strip.
- Connect Jumper Wires to each cut section (i.e.:  if you cut 1 Flex Strip into 2 pieces, you will need 2 Jumper Wires.  If you cut 1 Flex Strip into 3 pieces, you will need 3 Jumper Wires, etc.)  Jumpers are available in different sizes. 
- Attach to Hook-Up Wire (Red Wire to Ground, Black Wire to 12-Volt Power Source).

  We have customized one of our own bikes with these lights (shown below). 
  This is positively the easiest light mod there is.  All you need to do now is hook up a fused power source and switch to power up your lights.  Then you can place the LED strips anywhere you want.  The jumpers come in different lengths with connectors on both ends, allowing you to keep connecting LED strips together very easily.  If wanting to daisy chain LED strips you just need to have at least 6 LED's per segment (there is a connector every third LED).  When you want to connect power to everything, just cut one of the connector ends off and hook power to the wires.  The connectors make it very easy to put LED lighting on Tanks, Panels, Trim Pieces or anything else that you might need to remove sometime, because the connectors just unplug from the LED Strip.

Each strip can be cut (where indicated by scissors), giving you up to 13 sections per Flex Strip.  The Flex Strip and or Sections can be bent at any angle to fit different needs.  Adhesive on the back of each strip for easy mounting!

Shown below on one of our bikes, a nine segment portion attached to the frame and hidden.  Jumpers are hooked to the segment powering the segment up and also jumpering to the next segment to power that one up also.

Water and Shock Resistant. 
Dimensions:  Length: 24" , Width: 1/2" 
Low Power Requirements:  12V DC, 1/2 Amp! 
One Year Limited Warranty!

Additional Information